Welcome to D-FAN !

Company News:
About Us
Product Categories

DONGGUAN XINGDONG ELECTRONICS CO., LTD.
Address:LiShi Industrial Zone, QiaoLi Village, ChangPing Town,DongGuan City, GuangDong 523586, China
Tel: +86-769-83660708
Fax: +86-769-83660718
Email: info@d-fan.com.cn

URL:/eng/

Chiefly Choice co.,Ltd.
Add: 3rd Floor, NO.340 Kangning Street, Xizhi City, Taipei, Taiwan
Tel: +886-2-2692-6816
Fax: +886-2-2692-7030
Email:  james@chiefly-choice.com
Website: www.chiefly-choice.com
 

Korea Company: CHANG SHIN E&T
Add: #1113, Hanshin IT Tower,272,Digital-Ro, Guro-Gu, Seoul, Korea
Tel: +82-2-6093-6788 
Fax: +82-2-6093-8972
Phone: +82-10-6656-0330
E-mail: cs@csfan.co.kr
Contact: Junhong Kang(Mr. Kang)
 

      Guangzhou Office
      Tel: +86-20-85651751
      Fax: +86-20-38669584
      Office:
      Room 909Guaner Yongtai building, Congyun Road No.810,
      Baiyun District of Guangzhou,Guangdong,China

   Add: 603#,NO.395 Tangdenan Rd, Tianhe District,
    Guangzhou, China

news

You are here:Home > news

Cooling Fan Manufacturer conservation methods

Time:2014-10-28 Click:432Times

"Cooling Fan Manufacturer" from the inside of the motor in terms of its internal protection devices, there is a thermal breaker that is part of the coil windings short-circuited, causing a sharp increase in heat, breaker circuit, the motor this case, the general strike . This rarely happens. Another is to start capacitance becomes smaller, although the nameplate reads those parameters, but a long time, the capacitance is reduced, resulting in smaller starting torque of the motor, can not drive the load. This simple, remove the "Cooling Fan Manufacturer" capacitance, go for a new, same model should be no problem. But the best for a 20 percent larger than the original, and will get better results. The motor shaft axial gap is too large will cause can not drag the load. If it is demolished motor, shaft axial gap is too large to be adjusted by adjusting shims. When installing the motor, the rotor must be concentric with the bearing for the job, slowly tightening the screws diagonally want, and then use a screwdriver to knock wood shaft, making concentric. Demolition "Cooling Fan Manufacturer" motor is simple, but putting it back on again is not casually pretend to go back, do not occur above case, otherwise, direct repair "bad".

DONGGUAN XINGDONG ELECTRONICS CO., LTD.

Tel: +86-769-83660708

Fax: +86-769-83660718

Email:info@d-fan.com.cn

URL: /eng/
 

Address:LiShi Industrial Zone, QiaoLi Village, ChangPing Town,DongGuan City, GuangDong 523586, China

Follow Us

Main Products: DC Fan|Cooling Fan|AC Fan|Axial Fan|Cross Flow Fan|Exhaust Fan|Blower Fan|DC Axial Fan|DC Cooling Fan

Copyright©2014, DONGGUAN XINGDONG ELECTRONICS CO., LTD., All Rights Reserved. Tel:+86-769-83660708,,Fax:+86-769-83660718 E-mail:info@d-fan.com.cn

XML 地图 | Sitemap 地图